InLine® Bluetooth Audio Transceiver, Receiver/Transmitter, BT 5.0, aptX LL, 3.5mm + Toslink

Bei dem Transreceiver handelt es sich nicht um einen Konverter der das analoge Signal ins digitale und umgekehrt umwandelt. Dafür wird ein DAC benötigt.

You'll find the desciption how to connect also in the manual on page 9-11 https://www.inline-info.com/downloads/2_Dokumente/01_Handbuch/99151I.pdf

7.3 Configuration: Pairing in TX mode
Pairing with a Bluetooth headphone / speaker
Step 1: Connect the InLine® Bluetooth Audio Transceiver to your TV or computer using the appro-
priate connector cable. Place your Bluetooth headphone or speaker within 1 meter (3 feet) range
of the InLine® Bluetooth Audio Transceiver and set it into pairing mode.
Step 2: With transceiver powered on and TX/RX toggle switch set to „TX“, slide and hold the mul-
tifunction switch all the way to the right in the direction of the Bluetooth symbol. The LED indicator
light will flash red and blue / green to indicate that transceiver is ready to pair. Now release the
multifunction switch.
Step 3: Transceiver and your Bluetooth headphone or speaker have to be in pairing mode simulta-
neously in order to pair. Transceiver will remain in pairing mode for 10 minutes or until successfully
paired. Once paired, the LED indicator will turn solid blue / green (depending on the audio input
selection).
Step 4: Make sure the proper audio input source is selected on the transceiver. Select the corres-
ponding audio input (optical or AUX) on the back of the transceiver using the multifunction switch.
Step 5: The sound from your TV will now play through your Bluetooth headphone or speaker.
7.4 Multipoint streaming - pairing with two Bluetooth headphones
Step 1: Connect your first headphone to the audio transceiver by following the steps described
in section 7.3 for pairing.
Step 2: Get the transceiver in pairing mode by sliding and holding the multifunction switch till the
LED indicator flashes red and blue / green.
Step 3: Set your second headphone to pairing mode and wait until they connect.
Step 4: The sound from your TV will now play through both Bluetooth headphones simultaneously.
Note: Transceiver will provide the best possible audio quality and minimizes audio
latency only when used with headphones or receivers that support Qualcomm aptX
low latency technology.
When streaming to two headphones, if one of the headphones supports aptX and
the other does not, then standard Bluetooth audio streaming will be used with both
headphones.
7.5 Configuration: Pairing in RX mode
Pairing with a smartphone / tablet / PC
Step 1: Connect the InLine® Bluetooth Audio Transceiver to your music system using the appro-
priate connector cable.
Note
Note
Note
www.inline-info.com
Step 2: With the transceiver powered on and TX/RX toggle switch set to „RX“, slide and hold the
multifunction switch all the way to the right in the direction of the Bluetooth symbol. The LED in-
dicator will flash red and blue / green to indicate that transceiver is ready to pair. Now release the
multifunction switch.
Step 3: Turn on Bluetooth on your device and go to Bluetooth preferences. If necessary, refer to
the operating instructions of your device.
Step 4: Scan listed Bluetooth devices and select „InLine BT Transceiver“ to pair and connect. Once
paired, the LED indicator will turn to solid blue / green (depending on the audio input selection).
Step 5: Make sure the proper audio output source is selected on transceiver. Match the correspon-
ding audio output (optical or AUX) on the back of the transceiver using the multifunction switch.
Step 6: The music on your smartphone / tablets / PC will now play through your home stereo
system